MAXICURE
Electric Textile Dryer
Control Center
  • Isolated control panel from heat chamber.
  • Insures long life on electric components.
  • Solid state temperature controller with
    digital display
  • Emergency stop system at infeed end of
    the conveyor
Conveyor Belt Width
24” & 36”
Drive System
  • Teflon Coated heat resistant conveyor belt
  • Variable speed DC motor drive Digital Speed controller
CURING SYSTEM
Construction
Heavy, rigid solid construction Stainless steel construction in insulation chamber
Curing Chamber
  • Quartz Panel system delivers efficient cure
  • Three Stage drying system High Efficient Quartz Heating Element
  • Thyrister Power Pack inbuilt Less consumption of power Rigid Construction
AUTOMATIC TABLE DRYER
 
  • Uniform flock effects throughout the production.
  • Trolley attached power supplier.
  • No need to shake the flock handle.
  • Minimum attention required for operation.
  • High power out put efficiency.
  • Low wastage of flock powder.
  • No technical operators required.
  • Low power consumption.
  • Lesser man power.
  • No shocking hazards.
 
EXPOSING MACHINE
  Standard Features:

Solid, heave duty construction, Elastic, non-reflective blanket assures absolute contact between the positive and mesh , Instant start, shutter less, multi-spectrum light source for minimal exposure time, Micro controller based programmable controller with 100 program settings with key lock facility, High efficient vacuum system.
PRINTING MACHINE
  TEXTILE MACHNERES

  • Index pin / bearing registration.
  • Multi directional Micro registration.
  • Sturdy side screen clamps.
  • Off contact adjustment.
  • Interchangeable infra Red heating pannel.
  • Castor wheel mounted for easy mobility.
STRETCHING MACHINE
  STANDARD FEATURES:

  • Fully adjustable to accommodate various frame size.
  • Accurate control of air pressure.
  • Independent tensioning in both warp and weft directions.
  • Integrated design.
  • Tool-less operation.
SEMI AUTOMETIC SCREEN PRINTING MACHINE
  STANDARD FEATURES:

  • PRINT AREA:- 18"*24"/20"*30/30"*40
  • SCREEN FRAME THICKNESS:- 1"~ 1.5"
  • BED MOVEMENT:- +/- 10MM
  • PRINTABLE OBJECT THICKNESS:- 0-20 MM
  • CYCLE SPEED(NON-STOP):- 900/HR
  • COMPRESSED AIR:- 6KG CM2 /7 Lit / min
  • POWER SUPPLY (SERVO AUTO TAKEOFF):- 220 V AC/16 Amps/1PH /50Hz 3.5 HP(2.6 Kw)
TABLE CURER
 
AUTOMATIC TABLE DRYER
  • Solid Rigid Construction for continuous Production.
  • High Heat Efficient 12 KVA Infra Red Flash Emitter tpe heaters to travel continuous up to 200 Feet.
  • Various pitch stop adjustment for differen types of fabrics drying High adjustment PLC Drive
  • Only $ Units of power consumption per hour.
  • High Accuracy Dc drive rails Four high power Sensors to avoid Accidents.
 
Size:16"*20" (HATING AREA) 220V / SINGLE PHASE
 
The information and recommendation contained in the Company's literature or elsewhere are based on knowledge at the time of printing and are believed to be accurate. While such details are printed in good faith they are intended to be guide only and shall not bind the Company. Due to constant development. Customers are urged to obtain up-to-date technical informantion from representatives of the Company and not to rely exclusively on printed materials. Customers are reminded of the importance of obtaining and complying with the instructions for the handling and use of chemicals and materials supplied as the Company cannot accept responsibility for any loss or injury caused through non-compliance.